Alpha Technologies AlphaGen DCX3000 - Operator's Manual - Manual (Page 7)

041-028-B0-003, Rev. C 7
General Safety Information
• The manufacturer cannot anticipate every circumstance that may involve a hazard, therefore, these
warnings are not all inclusive.
• Do not use the generator or any of its parts as a step.
• Generator must be properly grounded.
• Do not place or operate the generator in standing water, or expose to a forced spray of water.
• Do not make or break any connections while generator is running.
• Fuel spillage cleanup is the responsibility of the operator and should comply with local codes and
regulations.
• Do not refuel the generator while engine is running. Allow generator to cool before refueling.
• For fi re safety, the generator must be properly connected, maintained, and in compliance with applicable
codes and regulations.
• Engine exhaust contains carbon monoxide gas, which can be deadly in closed or poorly ventilated areas.
• Prior to each use, inspect the generator for leaks and damage. Immediately repair or replace any
damaged parts.
• Never operate the generator near combustible materials.
• Ensure cables do not cross hot surfaces or sharp edges. Inspect cables before and after each use.
• Drain oil and empty the fuel tank before transporting. Fuel can leak from the fi ller cap if the generator is
tilted.
• Never refuel the generator in the vicinity of open fl ames of heat sources. Do not smoke near the
generator.
• The generator should be operated on level ground. If necessary, it may be operated on a grade <15°.
• Use only vendor-authorized repair parts.
• Do not operate generator unattended.
• Alpha Technologies’ products are subject to change through continual improvement processes. Therefore,
specifi cations and design layouts may vary slightly from descriptions included in this manual. Updates to
the manual are issued when changes affect form, fi t or function.
• This product is manufactured to conform to the Federal Communications Commissions (FCC) Part 15,
Class A regulations. It is intended to be used for commercial, industrial or business environments.
• This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
ATTENTION: