3 xm3 smart display — comm menu – Alpha Technologies XM3-HP Series - Quick Start Guide User Manual

Page 5

Advertising
background image

5.1

Verify Alpha DOCSIS Transponder operation as indicated below:

LEDs and Indications

Step

Communications State

ALM/RDY

DS

REG

RF

COM

1

Transponder Initializing/Searching for

Downstream DOCSIS channel

Flashing (Green)

Flashing

OFF

OFF

Flashing

2

DOCSIS Channel locked - Completing

upstream and network registration

Flashing (Green)

ON

Flashing

ON

(Green)

Flashing

3

Online - Registration Complete

Flashing (Green)

ON

ON

ON

(Green)

Flashing

4

Alpha DOCSIS Transponder fully

functional

Flashing (Green)

ON

ON

ON

(Green)

Bursts

* Blue RF LED indicates Rx/Tx Power at a warning level. Make the necessary RF level adjustments.
* Red RF LED indicates Rx/Tx Power at an alert level. Make the necessary RF level adjustments.

LED Color

Rx Range (dBmV)

Tx Range (dBmV)

Green

+10 to -10

0 to +50

* Blue

+15 to +10 and -10 to -15

+50 to +55

* Red

>+15 and <-15

>+55

5. Alpha DOCSIS Transponder and Smart Alphaguard LED's

5.2

Verify Smart AlphaGuard operation as indicated below:

LED State and Indications

LED Name

Color

State

Indication

Active

Green

Off

No power to SAG

Solid

Unit is on and communicating with power supply or in

Rest mode

Flash (90% on / 10% off)

Unit is on and operational

Flash (50% on / 50% off)

Actively balancing

Flash (10% on / 90% off)

Powersave mode

STRG A

STRG B

STRG C

STRG D

(ALARMS)

Red

Off

Normal operation

No string wires connected

Flash (50% on / 50% off (Minor

Alarm)

High delta mean

Check battery alarm

Solid (Major Alarm)

String A missing

String miswired

COMM-GENERAL

Verify Alpha DOCSIS Transponder communication parameters such as IP Address, RF Power Levels and Signal/

Noise Ratio on the COMM menu of the XM3 Smart Display. Press Enter <ENTR> to open the COMM-GENERAL

Menu enabling the operator to view values for the following parameters. Pressing the up or down arrow softkeys will

show two lines of information for each submenu item.

5.3

XM3 Smart Display — COMM Menu

Ethernet port LNK and ACT LED’s are on (LNK - Solid, ACT - Flash) only when connected to a laptop.

NOTE:

COMM-GENERAL
CM MAC ADDRESS

00:90:EA:A0:04:99

ESC

Press "Down" arrow softkey to

view next item(s) in menu.

COMM-GENERAL

CM MAC ADDRESS

00:90:EA:A0:04:99

CM IP ADDRESS

192.168.1.121

CM IPV6 ADR PREFIX

2001:123:456:789

CM IPV6 ADR POSTFIX

111:222:333:3434

CPE MAC ADDRESS

00:90:EA:00:52:33

Advertising