American Expedition Vehicles 3.5— 4.5 Dualsport suspension - Manual (Page 10)

8
NOTE: If you purchased a SC or RS suspension install High Steer Kit now (refer to instructions con-
tained in kit P/N: IJKS1002-E) then continue with step 12. For ST suspensions continue to step 11.
9.
A. Drill a 3/8 inch hole in the center of the axle
bump stop pad.
B. Place bump stop spacer inside springs.
C. Install AEV springs, keeping factory isolator in
place. Make sure to properly index the springs
on the lower spring seat.
D. Install and tighten supplied bump stop spacer
hardware.
A.
A.
10.
A. Install Shock Doubler brackets on both sides
as shown using supplied hardware.
B. Install AEV Shocks. If you are installing Remote
Reservoir Shocks install the reservoir bracket
and use the supplied hose clamps to secure
the reservoir portion of the shock into it.
B.
B. B.
bump stop pad
bump stop spacer