American Expedition Vehicles 3.5— 4.5 Dualsport suspension - Manual (Page 8)

6
FRONT SUSPENSION
7.
A. Raise Jeep and support the frame using jack stands or a hoist, such that the front axle can be low-
ered enough to remove the springs. Support the axle by placing fl oor jack under the center of the axle.
Remove the wheels.
A.
A.
A.
B. Loosen but DO NOT remove all 8 control arm bolts.
C. Disconnect the drive shaft. Make sure to mark both sides of the connection so you can properly align
it when you reconnect it. Tie loose end of the drive shaft up so it will not hang down. Failure to follow
this step may result in damage to your drive shaft.
D. Loosen but DO NOT remove the frame-side track bar bolt. Remove and save the axle-side track bar bolt
and fl ag nut.
C. D.