American Expedition Vehicles 3.5— 4.5 Dualsport suspension - Manual (Page 6)

4
3.
Carefully lower the axle using the fl oor jack enough to remove the springs. DO NOT overextend the wheel
speed sensor or locker wiring.
Remove the factory springs.
4.
Install the track bar tower as shown. Tighten the U-bolt to NO MORE than 40 ft lbs. NOTE: The trackbar
bolts will be reinstalled in the opposite direction from factory (A.) Use the lower mounting hole for 3.5”
suspensions (shown) and the upper for 4.5” suspensions.
Install AEV springs making sure to properly index them on the axle spring seat (B.)
A.
B.
REAR OF JEEP
2 Washers