Atec Anritsu-MT8220T - Manual (Page 18)

18 of 28 PN: 11410-00698 Rev. B MT8220T TDS
General Specifications BTS Master™ MT8220T
General Specifications
All specifications and characteristics apply under the following conditions, unless otherwise stated: 1) After 5 minutes of warm-up time, where the instrument is left in the ON
state; 2) Apply when using internal reference and performance sweep mode; 3) Subject to change without notice;
4) Typical performance is the measured performance of an average unit; 5) Recommended calibration cycle is 12 months.
Setup Parameters
System Status (Temperature, Battery Info, Serial Number, Firmware Version, Options Installed)
Self Test, Application Self Test, GPS
System Options Name, Date and Time, Ethernet Configuration, Volume,
Display (Brightness, Blank, Default, Black & White, Night Vision, High Contrast, Invert Black & White)
Share Center Frequency and Power Offset (All Modes or Not Shared)
Language (English, French, German, Spanish, Chinese, Japanese, Korean, Italian, Russian, User defined)
Reset (Factory Defaults, Master Reset, Update Firmware)
File Save As, Save Meas, Save, Save On Event, Recall Meas, Recall, Copy, Delete
Save/Recall Setups, Measurements, Screen Shots (JPEG - save only)
Delete By File Type, All, Selected
Internal Trace/Setup Memory > 30,000 traces
External Trace/Setup Memory Limited by size of USB Flash drive
Mode Switching Auto-Stores/Recalls most recently used Setup Parameters in the Mode
Connectors
RF Out Type N, female, 50 Ω, Maximum Input +23 dBm, ± 50 VDC, (Reflection In)
RF In Type N, female, 50 Ω, Maximum Input +30 dBm, ± 50 VDC
GPS SMA, female
External Power 5.5 mm barrel connector, 12 VDC to 14.5 VDC, < 5.0 A
LAN Connection RJ48C, 10/100 Mbps, Connect to PC or LAN for Remote Access
USB Interface Two Type A, Connect Flash Drive and Power Sensor
One 5-pin mini-B, Connect to PC for data transfer
Headset Jack 3.5 mm 3-wire headset jack
External Reference In BNC, female, 50 Ω, Maximum Input +10 dB
Reference Out BNC, female, 50 Ω, 10 MHz
External Trigger In/Clock Recovery BNC, female, 50 Ω, Maximum Input ± 5 VDC
IF Out BNC, female, 50 Ω, 140 MHz
Display and Keyboard
Display 8.4" Touch Screen, 800 x 600 Resolution
Keyboard Backlit (Red for Night Vision, White for all other display modes)
Battery Type Li-Ion
Battery Operation 2.5 hours, typical
Battery Charging Limits 0 °C to +45 °C, Relative Humidity ≤ 80 %
Electromagnetic Compatibility
European Union CE Mark, EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC
Australia and New Zealand C-tick N274
Interference, Emissions, Immunity EN 61326-1, EN 55011, EN 61000-4-2/3/4/5/6/11
Safety
Safety Class EN 61010-1 Class 1, Pollution Degree 2
Product Safety IEC 60950-1 when used with Anritsu supplied Power Supply
Environmental
Operating Temperature –10 °C to 55 °C
Maximum Humidity 85 % RH, non-condensing
Shock MIL-PRF-28800F Class 2
Storage –51 °C to 71 °C
Altitude 4600 m, operating and non-operating
Explosive Atmosphere MIL-PRF-28800F Section 4.5.6.3
MIL-STD-810G, Method 511.5, Procedure 1
Size and Weight
Size 315 mm x 211 mm x 77 mm, (12.4 in x 8.3 in x 3.0 in)
Weight 4.6 kg (10.2 lb)