Atec Anritsu-MT8220T - Manual (Page 6)

6 of 28 PN: 11410-00698 Rev. B MT8220T TDS
Specifications BTS Master™ MT8220T
Power Meter
General
Frequency Center/Start/Stop, Span, Frequency Step, Signal Standard, Channel #, Full Band
Amplitude Maximum, Minimum, Offset, Relative On/Off, Units, Auto Scale
Average Acquisition Fast/Med/Slow, # of Running Averages
Limits Limit On/Off, Limit Upper/Lower
Frequency Range 10 MHz to 7.1 GHz
Span 1 kHz to 100 MHz
Display Range –140 dBm to +30 dBm, ≤ 40 dB span
Measurement Range –120 dBm to +30 dBm
Offset Range 0 to +100 dB
VSWR 1.5:1 typical
Maximum Power +30 dBm without attenuator
Accuracy Same as Spectrum Analyzer
Application Options Impedance (50 Ω, 75 Ω, Other)
GPS Receiver
General
Setup On/Off, Antenna Voltage 3.3 V/5.0 V, GPS Info
GPS Time/Location Indicator Time, Latitude, Longitude and Altitude on display
Time, Latitude, Longitude and Altitude with trace storage
High Frequency Accuracy Spectrum Analyzer, Interference Analyzer, Wireless Measurements
when GPS Antenna is connected:
± 2.5 × 10 –8 with GPS On, 3 minutes after satellite lock in selected mode
GPS Lock Accuracy after antenna is disconnected:
± 5.0 × 10 –8 for 3 days, 0 ºC to 50 ºC ambient temperature
Connector SMA, female
Supplied Antenna 2000-1760-R GPS Antenna, SMA(m), 25 dB gain, 2.5 VDC to 3.7 VDC
High Accuracy Power Meter (Option 0019)
(Requires external USB Power Sensor)
Amplitude Maximum, Minimum, Offset, Relative On/Off, Units, Auto Scale
Average # of Running Averages, Max Hold
Zero/Cal Zero On/Off, Cal Factor (Center Frequency, Signal Standard)
Limits Limit On/Off, Limit Upper/Lower
Power Sensor Model PSN50 MA24105A MA24106A MA24108A/18A/26A
Description High Accuracy
RF Power Sensor
Inline High
Power Sensor
High Accuracy
RF Power Sensor
Microwave USB
Power Sensor
Frequency Range 50 MHz to 6 GHz 350 MHz to 4 GHz 50 MHz to 6 GHz 10 MHz to 8/18/26 GHz
Connector Type N(m), 50 Ω Type N(f), 50 Ω Type N(m), 50 Ω Type N(m), 50 Ω
(8/18 GHz)
Type K(m), 50 Ω
(26 GHz)
Dynamic Range –30 dBm to +20 dBm
(0.001 mW to 100 mW)
+3 dBm to +51.76 dBm
(2 mW to 150 W)
–40 dBm to +23 dBm
(0.1 µW to 200 mW)
–40 dBm to +20 dBm
(0.1 µW to 100 mW)
VBW 100 Hz 100 Hz 100 Hz 50 kHz
Measurand True-RMS True-RMS True-RMS True-RMS, Slot Power,
Burst Average Power
Measurement Uncertainty ± 0.16 dB 1 ± 0.17 dB 2 ± 0.16 dB 1 ± 0.18 dB 3
Data sheet
(for complete specifications)
11410-00414 11410-00621 11410-00424 11410-00504
Notes: 1. Total RSS measurement uncertainty (0 ºC to 50 ºC) for power measurements of a CW signal greater than –20 dBm with
zero mismatch errors.
2. Expanded uncertainty with K = 2 for power measurements of a CW signal greater than +20 dBm with a matched load.
Measurement results referenced to the input side of the sensor.
3. Expanded uncertainty with K = 2 for power measurements of a CW signal greater than –20 dBm with zero mismatch
errors.