Atec Anritsu-MT8220T User Manual
Page 4
PN: 11410-00698 Rev. B
MT8220T TDS
Specifications
BTS Master™ MT8220T
Spectrum Analyzer
Measurements
Smart Measurements
Field Strength (uses antenna calibration tables to measure dBm/m
2
, dBµV/m, dBV/m, dBmV/m, V/m,
W/m
2
, dBW/m
2
, A/m, dBA/m and W/cm
2
)
Occupied Bandwidth (measures 99 % to 1 % power channel of a signal)
Channel Power (measures the total power in a specified bandwidth)
ACPR (adjacent channel power ratio)
AM/FM/SSB Demodulation (AM, wide/narrow FM, upper/lower SSB), (audio out only)
C/I (carrier-to-interference ratio)
Emission Mask (recall limit lines as emission mask)
Coverage Mapping (requires Option 0431)
IQ Waveform Capture (requires Option 0024)
Setup Parameters
Frequency
Center/Start/Stop, Span, Frequency Step, Frequency Offset, Signal Standard, Channel #
Amplitude
Reference Level (RL), Scale, Attenuation Auto/Level, RL Offset, Pre-Amp On/Off, Detection
Span
Span, Span Up/Down (1-2-5), Full Span, Zero Span, Last Span
Bandwidth
RBW, Auto RBW, VBW, Auto VBW, RBW/VBW Ratio, Span/RBW Ratio
Application Options
Bias-Tee (On/Off), Impedance (50 Ω, 75 Ω, Other)
Sweep Functions
Sweep
Single/Continuous, Manual Trigger, Reset, Detection, Minimum Sweep Time, Trigger Type,
Gated Sweep (requires Option 0090)
Sweep Mode
Fast (100x Performance), Performance, No FFT, Burst Detect (1000x Fast in 15 MHz span)
Detection
Peak, RMS/Avg, Negative, Sample, Quasi-peak
Triggers
Free Run, External, Video, Change Position, Manual
Trace Functions
Traces
Up to three Traces (A, B, C), View/Blank, Write/Hold, Trace A/B/C Operations
Trace A Operations
Normal, Max Hold, Min Hold, Average, # of Averages, (always the live trace)
Trace B Operations
A → B, B ← → C, Max Hold, Min Hold
Trace C Operations
A → C, B ← → C, Max Hold, Min Hold, A – B → C, B – A → C, Relative Reference (dB), Scale
Marker Functions
Markers
Markers 1-6 each with a Delta Marker, or Marker 1 Reference with Six Delta Markers,
Marker Table (On/Off/Large), All Markers Off
Marker Types
Style (Fixed/Tracking), Noise Marker, Frequency Counter Marker
Marker Auto-Position
Peak Search, Next Peak (Right/Left), Peak Threshold %, Set Marker to Channel,
Marker Frequency to Center, Delta Marker to Span, Marker to Reference Level
Marker Table
1-6 markers frequency and amplitude, plus delta markers frequency offset and amplitude
Limit Line Functions
Limit Lines
Upper/Lower, On/Off, Edit, Move, Envelope, Advanced, Limit Alarm, Default Limit
Limit Line Edit
Frequency, Amplitude, Add Point, Add Vertical, Delete Point, Next Point Left/Right
Limit Line Move
To Current Center Frequency, By dB or Hz, To Marker 1, Offset from Marker 1
Limit Line Envelope
Create Envelope, Update Amplitude, Number of Points (41), Offset, Shape Square/Slope
Limit Line Advanced
Type (Absolute/Relative), Mirror, Save/Recall
Frequency
Frequency Range
150 kHz to 7.1 GHz (usable to 0 Hz)
Maximum Continuous Input
+30 dBm
Tuning Resolution
1 Hz
Frequency Reference
Aging: ± 1.0
×
10
–6
/10 years
Frequency Span Accuracy
± 3
×
10
–7
(25 °C ± 25 °C) + aging, 10 Hz to 7.1 GHz including zero span
Sweep Time
Minimum 100 ms, 10 μs to 600 s in zero span
Sweep Time Accuracy
± 2 % in zero span
Bandwidth
Resolution Bandwidth (RBW)
1 Hz to 3 MHz in 1–3 sequence ± 10 % (–3 dB bandwidth)
Video Bandwidth (VBW)
1 Hz to 3 MHz in 1–3 sequence (–3 dB bandwidth)
RBW with Quasi-Peak Detection
200 Hz, 9 kHz, 120 kHz (–6 dB bandwidth)
VBW with Quasi-Peak Detection
Auto VBW is On, RBW/VBW = 1
VBW/Average Type
Linear/Log
Spectral Purity
SSB Phase Noise
–100 dBc/Hz @ 10 kHz, 20 kHz, and 30 kHz offset from carrier
–102 dBc/Hz @ 100 kHz offset from carrier