Avision AM7100NF User Manual - Manual (Page 56)

49
78. Quality Set default quality type.
Standard (200 x 100 dpi):
Suitable for most typed
originals.
Fine (200 x 200 dpi):
Good for small print.
Extra Fine (200 x 400
dpi): Good for small print or
artwork and transmits slower
than Fine resolution.
Photo (200 x 400 dpi):
Use when the original has
varying shades of gray.
Note: Faxes are sent in the
specified resolution if that
resolution is supported by
the receiving fax machine.
Choice: Standard,
*Fine, Extra Fine,
Photo
79. Brightness To lighten or darken your
document. Choice: Light,
*Normal, Dark
710. SPKR Volume Set if you wish to turn on
the speaker during fax
communication. *ON, OFF
711. Tx Report Choose if you wish to print
the fax transmission report.
This report lists the time and
date of transmission and
whether the transmission
was successful (OK). If you
select ON, the report will be
print after each
transmission. If you select
Error, the report will only be
printed when a fax fails to
transmit.
*OFF, ON, Error
712. Redial Count Sets the number of redial
attempts if the number
dialed is busy.
Choice: *0, 1, 2
(The Redial value 0
indicates no redial.)
713. Redial Int. The redial interval setting
selects the number of
minutes between each redial
if the number dialed is busy. Choice: 10 sec., 30
sec., *1 min., 2 min.,
3 minutes.