B&K Precision 830C - Manual - Manual (Page 89)

87
Limit function.
CALC:LIM:UPP? 07 ; Query the upper value
of the mode 7.
Note: CALCulate:LIMit:MODE? Query will
respond with an error if meter is not in limit
function and if the state of limit function is
disabled. To set meter to limit function, use the
CALCulate:FUNCtion command.
CALCulate:LIMit:STATe <Boolean>
Description: Enable or disable the Limit
function of the calculation.
Example:
CALC:LIM:STAT OFF
CALCulate:TOLerance:RANGe <1 | 5 | 10 | 20>
Description: Set the tolerance range of the
Tolerance function.
Example:
CALC:TOL:RANG 5 ; Set 5%
tolerance range.
Note: Tolerance range can only be set when
tolerance function mode is set. When this
function is not set as the current mode,