MoTeC DBW-4 - Manual (Page 13)

MoTeC DBW-4 13 Introduction
Diagnostic/Fault Condition Monitoring
To view the Diagnostic/Fault Information, select the Monitor Faults option under the File menu. All red indicators
indicate an error condition, green indicators indicate OK. Note that if any error conditions are present the particular
PID Controller will be shutdown. If any drive by wire type PID Controllers are shutdown then all other drive by wire
type PID Controllers will also be shutdown.
Firmware Upgrades
The Send Firmware option in the File menu can be used to upgrade the firmware of the DBW-4 unit. The DBW-4 unit
must be powered and connected to the CAN cable to perform the upgrade.