MoTeC MDC - Manual (Page 12)

MoTeC MDC 10 Setup
Speed Axis
Up to 11 values can be specified for the speed axis that is used in all of the user mode Braking and Acceleration
tables. The axis values must be ascending and duplicate values are not allowed. Spacing between values is not
fixed, allowing non linear axes.
Throttle Axis or MAP Axis
Up to 11 values can be specified for the throttle or ECU Efficiency axis that is used in all of the user mode tables.
The table type (throttle or ECU Efficiency) is determined by the Lock Table Axis option. The axis values must be
ascending and duplicate values are not allowed. Spacing between values is not fixed, allowing non linear axes.
Monitoring MDC Data
Live data from a connected MDC may be monitored using the Online | Monitor Channels option (or the F3 hotkey)
to open the Monitor Channels window.
Sending Firmware
The MDC firmware is user upgradeable from a PC connected to the MDC with the MoTeC UTC (USB To CAN) or
the MoTeC CAN cable.
To upgrade the firmware the MDC must be powered and connected to a PC with the MDC Manager software
installed. Use Online | Send Firmware to send the current firmware to the MDC.