MoTeC MDC - Manual (Page 8)

MoTeC MDC 6 Functionality
The ECU sends the calculated engine efficiency point (based on manifold pressure, throttle position, mass flow,
etc) to the MDC.
The MDC sends wheel speeds, longitudinal and lateral G, diff parameters and fault codes to the ECU.
See Appendix D – ECU Communications for more information on configuring ECU communications.
Miscellaneous functions
Fault indication
Faults are indicated by flashing the mode light on the dash. The light will continue to flash until there have been no
faults present for 2 seconds.
Fault codes and diagnostic codes are included in the CAN diagnostic messages, as described in Appendix A –
Fault Codes.
ABS Active Detection
ABS Active Detection may be disabled to ignore the status of the ABS in the diff lock calculation. This is the default
setting.
See Setup | Input in the MDC Manager section.