MoTeC M1 Tune User Manual - Manual (Page 46)

User Manual
USING M1 TUNE
Printed documents are not controlled Page 45
11.2 USING SUPPLIED WORKSHEETS
Using the supplied Worksheets is the easiest way to use M1 Tune for
specific tasks. MoTeC have made available sample Worksheets with
each Package that make performing these tasks easier. These
Worksheets are contained within the Workspace provided with the
Package. The Workspace contains three Workbooks, they are Tuning,
Setup and Initial Configuration.
11.2.1 Initial Configuration Workbook
Example Worksheets in the Initial Configuration Workbook
The Initial Configuration Workbook is designed to include Worksheets that are normally be filled
in before the ECU is plugged in, or before the engine is started. Among others, this workbook
allows the configuration of the Transmission, Cylinder TDC's, Fuel Injectors and CAN
information.
Unique to the Configuration Workbook is the Test Modes Worksheet. This sheet contains the
settings to allow the testing of auxiliary outputs, run an Ignition timing test, and to complete the
DBW step test.
11.2.2 Setup Workbook
Example Worksheets in the Setup Workbook
The Setup Workbook contains Worksheets that can be used either offline or online, but they
should be filled in before starting the engine. After starting the engine, some of these settings
may need modifying.
11.2.3 Tune Workbook
Example Worksheets in the Tune Workbook
The Tune Workbook includes sheets that are generally used when tuning the running engine.
From ignition and fuel main tables, to trims, starting, transients and closed loop.
Note: These Worksheets are just a starting point for how to configure the ECU. There
may be extra or specialised sheets that can be added as required.