MoTeC PLM - Manual (Page 2)

MoTeC PLM User’s Manual
CAN Unit Number Display .........................................................................................26
RS232 Messages ........................................................................................................27
Specifications...................................................................28
Meter .................................................................................... 28
Appendices ......................................................................31
Appendix A – Lambda to Air Fuel Ratio Table ........................................................31
Appendix B – PLM Display Codes ............................................................................32
Appendix C – PLM CAN Diagnostic Codes ............................................................33
Appendix D – PLM Connector Details ......................................................................34
Appendix E – Sensor Wiring Details ........................................................................36
Bosch LSU 4 Sensor.............................................................. 36
NTK – UEGO Sensor.............................................................. 38
Appendix F – PLM to ECU Wiring Details................................................................40
Analog Output........................................................................ 40
CAN...................................................................................... 40
Appendix G – PLM to ADL Wiring Details ................................................................41
Appendix H – General CAN Bus Wiring...................................................................42
Appendix I – PC Comms Wiring ...............................................................................43
Appendix J – Analog Output Wiring ..........................................................................44
Appendix K – Digital Input Wiring..............................................................................46
Typical wiring for switches....................................................... 46
Typical wiring for RPM measurement ....................................... 46
Appendix L – Glossary................................................................................................47
Appendix M – CAN Messages Format.....................................................................48
Appendix N – RS232 Message Format...................................................................53
Appendix O – Recommended CAN Collect Configuration ..................................54
Appendix P – Dimensions .........................................................................................57
 Copyright – Motec Pty Ltd – 2001-2005
The information in this document is subject to change without notice.
While every effort is taken to ensure correctness, no responsibility will be taken for the consequences of any
inaccuracies or omissions in this manual.
23 June, 2005