MoTeC PLM - Manual (Page 28)

28 Specifications
Specifications
Meter
Power Supply
Input Voltage Range 7 to 16Volts
Input current 60mA typical, backlight off
110mA typical, backlight on
Plus sensor heater current
Protection Reverse polarity protected
Load Dump Clamp Max 40V at 100 Amp 100msec
Sensors
Sensors 1
Compatible Types Bosch LSU 4/ Bosch LSU 4.2/ NTK UEGO
Calibration Methods Automatic using sensor’s built in calibration resistor
Manual Table Entry
Known Oxygen Environment
Calibration Constant
Type Detection Manual
Sensor Thread M18 x 1.5
Max Exhaust Temp 850 deg
Normal Temp Range 150 – 800 deg
Measurements
Lambda 0.7 to 32.0
0 2 0 to 22%
A/F Ratio Fuel dependant (see lambda range)
Accuracy +/- 1.5% (sensor specific)