MoTeC VCS - Manual (Page 16)

12 Configuration
The Medium gauge set includes, in addition to the elements of the Small set,
a G-force meter and two alpha numeric lines (default Lap number and Lap
time).
Note: Throttle bar not displayed
The Large gauge set includes, in addition to all elements of the Medium set, a
steering wheel and an alphanumeric line (default Last lap time).
Note: Brake bar not displayed
Picture in Picture (PIP)
The VCS is capable of recording the inputs from 2 cameras to provide a
Picture in Picture display. The location of the picture from the second camera
can be positioned in any corner of the screen.
CAN Communication
The VCS connects to a CAN bus. This enables it to communicate with other
devices on the same bus and use data from a Data Logger (ADL3, SDL, ACL)
or 'hundred series' ECU (M400, M600, M800, M880).
To enable CAN communications
1. Select the Enabled check box.
2. In the Speed list, click the required speed.
The VCS communication speed must be set to the same rate as the
communication speed of all other devices connected on the CAN bus.
The default value is 1 Mbit.