MoTeC VCS - Manual (Page 9)

MoTeC Installation 5
The VCS recorder has four connectors:
• A USB socket to connect to a laptop (D)
• A
power/CAN connector (C)
• Two
identical connectors (A and B) for two cameras and microphones.
The kit contains the following looms and cables:
• A USB cable to connect a laptop (#61149)
• An adapter loom to connect one camera and microphone (#61148)
• An unterminated loom for power/CAN (#61154).
Important: The VCS software must be installed before connecting the
VCS recorder to the laptop.
CAN (Controller Area Network) Wiring
The VCS connects to a CAN bus. This enables it to communicate with other
devices on the same bus and use data from a Data Logger (ADL3, SDL or
ACL) or a 'hundred series' ECU (M400, M600, M800, M880).
VCS Manager Software Installation
VCS Manager software is used for retrieving the audio and video data and for
configuration, testing and general management of the VCS.
Important: The VCS software must be installed before connecting the
VCS recorder to the laptop.
PC Requirements
VCS Manager is compatible with Windows XP or Vista operating systems.
The VCS connects to the PC via a USB port.
Installing VCS Manager Software
• Go to the MoTeC website at www.motec.com, navigate to
software/latestreleases and select the software.
• Save the selected file in your preferred location (for example desktop).
• When downloading is finished, double click on the file and click Run.
• Follow the instructions in the Install Shield Wizard.
• To start the program after installation, click the icon on the desktop.