PA Industries Advantage Servo Roll Feed SRF-5/8/12/16/20/24/28/32/36 - Installation Manual - Manual (Page 3)

ULTRA ADVANTAGE SERVO ROLL FEED 2/14/2003
3
1 INSTALLATION
1.1 MECHANICAL INSTALLATION
The Ultra Advantage Servo Roll Feed is supplied with an adjustable mounting bracket. The feed should be securely
mounted to the press frame. (A transition bracket is sometimes required in certain applications.) The feed should be
centered, square, and perpendicular to the pass line of the press. It should be mounted at a height that will accommodate
the appropriate die sets. The feed has a pass line height adjustment of ±1.2 inches. (Note: The centerline of the Feeder
is NOT the centerline of the rolls.) Refer to FIGURE 1 for dimensions.
The feeder may be used to push or pull strip stock through the die.
If pilot locating pins are used in your die sets, the optional mechanical roll release bracket should be attached to the press
ram. It must be mounted in such a way as to provide roll release at the proper time and be adjustable for different die
sets.
If the optional electro-pneumatic piloting is used, another cam switch will be necessary for controlling feed roll opening
and closing.
FIGURE 1