PA Industries Advantage Servo Roll Feed SRF-5/8/12/16/20/24/28/32/36 - Installation Manual - Manual (Page 9)

ULTRA ADVANTAGE SERVO ROLL FEED 2/14/2003
9
1.7 RUNNING THE FEED
Put the Ultra Advantage into “Auto” mode and press the Cycle Start button. The Ultra
Advantage Servo Roll Feed will now follow the press until it is stopped by the Operator,
counter, emergency stop, or feed error.
TYPICAL 180 DEGREE FEED ANGLE (FROM 260 DEGREES TO 80
DEGREES) WITH MECHANICAL PILOT RELEASE:
FIGURE 5