Schreiber Chillers ASM010 City Water Switchover - Manual (Page 2)

Mounting
There are four mounting keyholes on the back of the chiller. At least two
must be used to support the panel’s weight (55 lbs). Refer to Figure 1.
Electrical
The 110V power supply is connected using the hole on the lower right of the
panel. Is 208 or 220V power must be used, the internal transformer will have to
be rewired. See the electrical section in the back.
It is recommended to wire the incoming power to a plug and receptecale to allow
easy power down of the unit.
Plumbing
All of the plumbing connections are 1” Female IPS. The supply connections are
on the left side of the panel, the load connections are on the right.