Neff C77V60N2 - Manual (Page 45)

Neff C77V60N2 | 03/2011
English | 45
Information and settings
Use i (1) to display information (press briefly)
and adjust settings (hold down for at least
three seconds).
Displaying information
In the Info menu (press i (1) briefly) you can
call up the following information:
X
when it is necessary to descale the
appliance
X when it is necessary to clean the
appliance
X when it is necessary to change the filter
X how much coffee has been dispensed
since the appliance was first put into
operation
X how many milk drinks have been
dispensed
X how much hot water has been prepared
Displaying settings
Hold down i (1) for at least 3 seconds; the
different setting options are then displayed:
Settings
Language Cup volume
English
Use
Y
(2) and
Z
(5) to switch between the
different setting options. The currently active
setting is always shown in a larger font. You
can change the setting that is currently dis-
played using the navigation button (4).
To exit the menu, press i (1) again.
The changes you have made
are saved automatically. It is
not necessary to confirm them
additionally.
The following setting options are
available to you:
Language : Press the navigation button (4)
to select the display language.
Cup volume : The per-cup quantity can be
set separately for each type of drink and
each cup size (“Set per-cup quantity” on
page 46).
Water hardness : Press the navigation
button (4) to select the required water
hardness (1, 2, 3 or 4) (refer also to “Check-
ing and setting the water hardness”).
Coffee temperature : Press the navigation
button (4) to set the coffee temperature.
Auto off after : Press the navigation but-
ton (4) to enter the time span after which
the appliance should automatically switch
to “energy saving mode” following the last
drink preparation. A time between 5 minutes
and 8 hours can be set. The default time is
one hour, but this can be shortened to save
energy.
Contrast : The display contrast can be set
from – 4 to + 4 with the navigation button
(4). The default setting is 0.
Illumination : The lighting can be set to Off ,
On (factory setting) or Off after 5 min .
Water filter : Each time a new water filter
is inserted in the water tank (8), it must be
rinsed:
1. Place the water filter in the water tank
(8) and fill the tank with water up to the
“max” mark.
2. Use the navigation button (4) to select
Press
Y
and press
z
(6).
3. Place a container with a capacity of 0.5
litres under the milk frother (19).
4. Press
z
(6). Water will now run first
through the filter to rinse it and then into
the container.
Empty the container. The appliance is ready
to use once more.