Castle TSM-12 - Manual (Page 10)

4. To install your drill motor it should be rotated so that the vertical feature on the motor
cowling is in contact with the Motor Stop Tab on the small motor carriage. (Fig 8).
Align the drill motor with the small motor carriage as shown. (Fig 9) You DO NOT
want a gap between the tab on the motor carriage and the drill motor cowling. (Fig
10).
Motor Stop
Tab
Fig 8
Fig 10
Incorrect
Correct
Fig 9
Note: Failure to properly align the drill motor in the small motor carriage may result
in pilot holes that are off-center.
5. Tighten the hose clamp with a slotted screw driver
(Fig 11).
Fig 11
CASTLE, INC TSM‐12 OWNERS MANUAL V1.0 Page 10 of 23