Castle TSM-12 - Manual (Page 13)

CASTLE, INC TSM‐12 OWNERS MANUAL V1.0 Page 13 of 23
4 Operating Instructions Operating Instructions
1. Check to be sure the switch on top of the machine is in the OFF position and then plug
the TSM-12 into a 110 volt grounded power supply.
2. Place material to be pocketed on the work table under the clamp and squarely against
the rear face.
3. Push forward on clamp lever (red handle). Confirm that the material is held securely in
place (Fig 17), test by manually pulling on the material. If material is loose, adjust the
foot on the clamp as necessary to assure the material is held securely. No tools are
necessary to adjust the clamp foot, simply hold the lower nut between your fingers, and
loosen the wing nut with your other hand (Fig 18).
Fig 17 Fig 18
4. To operate, move the power switch to the ON
position. Both motors should start. It may be
necessary to turn on the individual motor switches. If
not done at time of installation.
Fig 19