Pilot drill height adjustment – Castle TSM-21 Serial 61064 and lower (Mead) Operator Manual User Manual
Page 10
Figure 6
The plate has two sides that can be used as settings for different processes in the shop.
Pilot Drill Height Adjustment
On the sides of the cabinet box loosen but do not remove the nuts securing the pivot point
of the motor carriage assembly to the cabinet box.
From the back door:
The carriage is mounted on into the case on a plate. (Figure 7)
Figure 7
Begin by removing the nut and bolt for the plate on the right side that are closest to
you.
Next loosen, BUT DO NOT REMOVE, the nut on the same plate that is farther away
from you.
Slide the plate in an upward motion one hole position to raise the drill by 1/16".
Reattach the nut and bolt closest to you, tighten down.
Tighten nut on far side
Repeat for the other side.
On the sides of the cabinet box tighten the nuts securing the pivot point of the motor
carriage assembly to the cabinet box.
8