Castle TSM-21 Serial 61064 and lower (Mead) Operator Manual - Manual (Page 6)

ƒ Plug the machine into a grounded 110V 20-amp outlet. Place a piece of scrap against the
face plate while depressing the safety buttons, and step on the foot pedal. Be sure to keep
your hands clear of the clamp. A full cycle should take 1 - 1 ½ seconds.
ƒ Inspect the pocket. If the drilled hole is off center, it can be centered using the adjusting
nut just below the drill motor. (Figure 2)
Figure 2
ƒ The router feed rate is adjusted using the flow control knob next to the air supply port.
Turning it clockwise will slow feed rate, counter-clockwise will speed it up. If the feed
rate is too slow it will burn bits.
4