Castle TSM-21 Serial 61064 and lower (Mead) Operator Manual - Manual (Page 24)

22
ƒ
If continuity IS registered then the distance between the mounted assembly needs to be
reduced by 1/16 of an inch on each side.
ƒ
The laminate strip on the front of the machine must be removed to access the screws that
retain the switch.
ƒ When installing the new switch it does not matter which side the red & black wire go to.
ƒ The magnet is sealed into its housing closer to one side than the other. When installing
the magnet, make sure that the side the magnet is sealed closer to is facing the switch.