J&M GRAIN CARTS Leaner Setup - Manual (Page 16)

STEP - T10.0
STEP - 1.0
STEP - T11.0
Insert the 1”x1” 14ga x 192” long square tube into the sleeve on the Canvas Tarp that is on the op-
posite side of the Stiffening Patch. Center the canvas tarp on the 1” x 1” 14ga x 192” long square
tubing. There should be aproximately 2” (5cm) of tubing sticking out each end of the tarp. Use a 1/4”
drill bit to drill through the canvas tarp and one wall of the 1” x 1” 14ga x 192” long square tubing.
(See STEP-8.1) Repeat and drill a hole at the same location on the opposite end of the tubing. Use a
hammer to install both 1/4” (6.35mm) drive rivets.
-15-
STANDARD GRAIN CART TARP INSTALLATION
Stiffening Patch