J&M GRAIN CARTS Leaner Setup - Manual (Page 18)

STEP - T14.0
-17-
STANDARD GRAIN CART TARP INSTALLATION
Install the universal joint using two 3/8”-16 x 2” hex bolts and two 3/8”-16 centerlock hex nuts.
Install the tarp crank handle using one 1/4”-20 x 2 1/2” hex bolt and one 1/4”-20 centerlock hex nut.
(Note: Universal joint may be pre-assembled.)
3/8”x2”
Universal Joint 1/4”x2 1/2
Crank Handle
Install each tarp standoff at each end of the grain cart wall on the off auger side with two
1/4” x 1 1/2 self tapping bolts. Place it about 2” down from the drip edge along side of the
corner brace.
Tarp Standoff
STEP - T15.0