J&M 500ST Remote - Manual (Page 8)

MEGA REMOTE
7
first unit to change is the
weight, which will start
blinking. Using the UP/DOWN
buttons the weight can be
changed, to move to the next
unit press the SCROLL once
which will give the control to
change the default door.
Holding the SCROLL
pushbutton for another 3
seconds will save the new
weight.
Auto Reset
After setting a weight to
dispense, pressing the CONV
START push button will start
the automatic dispense mode
and will continue to unload
until it almost reaches the
selected weight, then the unit
will close the door and will
open the selected door again
for fine tuning until the unload
is completed.
Holding the scroll button on
the weight to dispense page
for 4 seconds, will get the unit
into auto mode again .
Enable/Disable Display
Hold both UP and DOWN
pushbuttons simultaneously
for 10 seconds to enable or
disable the display.
Scale Unit Setting
a. Serial Baud rate:
9600
b. Parity: None
c. Data bits: 8
d. Stop bits: 1
USING THE OPTIONAL
PALM™ INTERFACE
The Patented Palm Pilot™
interface, US patent No.
6,907,302, software is a very
useful tool for troubleshooting