J&M 500ST Remote - Manual (Page 9)

MEGA REMOTE
8
the control system.
To use this tool, connect the
Palm™ serial cable to the
serial connector on the
receiver control harness or
adaptor, and apply power to
the system.
Main Page
Use the Palm’s stylus pen and
tap the icon J&M 1.0 to
launch the application.
DIAGNOSTIC
Tap the Diagnostic button to
see the diagnostic screens,
which shows the present state
of remote communications,
and system I/O.
RF Communications Page
When the round circle next to
a label is dark, the
corresponding ON/OFF input
or output is sensed to be
active or ON.