Hunter 99023 Bowl Light Fitter - Manual (Page 4)

MA003-01 • 07/24/13
1.888.830.1326
4
Lift the light kit up to meet the lower
switch housing. Install the two light kit
screws. Tighten screws.
If necessary, attach the extension chain
provided to the fan pull chain coming
from the switch housing. Then feed the
end of the extension chain through the
grommeted hole in the light kit.
Using the single pin connectors, connect
the black or blue wire from the fan to the
black wire from the light kit. Connect the
white wire from the fan to the white wire
from the light kit.
TYPE-A ASSEMBLY INSTRUCTIONS
Do not allow the light kit to hang
only by the wire connections!
If your fan does not have pin connectors on
the wires coming from the switch housing,
install the wiring harness provided. Using
the provided wire connectors connect the
white wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the black
wire from the wire harness.
Wire
Connector
Switch
Housing
Grommeted
Hole
Light Pull
Chain
Fan Pull
Chain
Light Kit
Screw
1 2
3 4