CEMB USA C65 (G) - Manual (Page 11)

I 0559 - 11
10
b
a
d
GB
5.3.3 - Manual presetting
If necessary, the dimensions can be inserted or edited in manual mode as follows:
- press +
4
or else press
6
from the Dimensions in automatic mode screen (which can be reached
by pulling out the distance + diameter gauge).
- press to select the dimension to be preset .
- press
2
/
3
to preset the required value.
- press 5 to change unit of measurement.
- press 6 to preset the dimensions for the ALU-S correction mode
Defi nition of dimensions:
d = DIAMETER: Preset the nominal diameter stamped on the rim.
b = WIDTH:
Preset the nominal width indicated on the rim.
a = DISTANCE: Preset the distance of the inside of the wheel from the machine, after measuring
it with relative gauge as described in fi g. 8.
Select Unit