CEMB USA C65 (G) - Manual (Page 9)

I 0559 - 9
b
Pos B
Pos A
8
b b
GB
5.3 - Presetting of wheel dimensions
5.3.1 - Automatic Presetting
The screen appears upon removing the distance + diameter gauge.
The indication “dimension acquired” is given by the symbol of the correction weight which changes from blue to red.
- Standard wheels: Using the appropriate handgrip, move the end of the gauge against the rim in one of the
positions A/B shown in fi gure 8:
- Hold the gauge still in position for at least 2 seconds.
N.B. - Always use the round part of the gauge striker surface.
INDICATOR
L.T. function enabled
(see
BUTTONS ENABLED )
INDICATOR: Width
Sonar function
enabled
If the beep signal is enabled (see ACUSTIC
SIGNAL ) , successful acquisition of the dimensions
is accompanied by a “beep”.
- Press
6
- In manual mode, preset width “b”
(see
MANUAL PRESETTING ).
- Normally the “nominal” width is stamped on
the
rim; or else measure dimension “b” with the
calliper gauge (standard accessory).
AUTOMATIC WIDTH MEASUREMENT (OPTIONAL)
Gradually lower the guard after carrying out measurement of distance + diameter in automatic mode.
If the width measured is incorrect (out of range), the following message appears:
“Sonar measure is out of range:”
“F1 = repeat”
“F2 = manual set-up”
Manual