CEMB USA C75SE (C) - Manual (Page 18)

I 0322 - 18
I 0322 - 19
GB GB
5.5 - RESULT OF MEASUREMENT
After performing a balancing spin, the unbalance values are displayed as well as arrows useful for positio-
ning the point of application of the correction weight. After positioning the wheel, apply the weight in the
12 o’clock position. When the beep signal is enabled (see section ACUSTIC SIGNAL), reaching of the
correction position is accompanied by a “beep”.
If the unbalance is less than the chosen threshold value, the “OK” appears instead of the unbalance value
to indicate, on that particular side, the wheel is in tolerance; the residual unbalance can be displayed by
pressing button
with an accuracy of 0.5 g (0.1 oz).
The following buttons are enabled:
Display of residual unbalance
Selection of correction mode (STATIC/DUAL SURFACE). When the mode is changed, the
unbalance values are recalculated automatically on the basis of the previous spin.
Simultaneous display of the dynamic+static unbalance can be enabled through the special
function in Setup (see par. 6.1.1).
: Eccentricity measurement graph (OPTIONAL).
N.B : 1. The symbol above the key is flanked by the symbol
!
if the eccentricity of
the first harmonic exceeds the limit set in the setup parameters (First harmonic limit).
2. When this push button is held down for more than 1.5 seconds, eccentricity
measurement is temporarily disenabled (enabled in GENERAL SETUP).
To re-enable eccentricity measurement, press push button [4] again for more than 1.5
seconds. Every time the machine is switched on, the status of eccentricity measure
ment reflects the settings in GENERAL SETUP.
Split control for splitting of unbalance over presettable components ( “SPLIT” CONTROL ). Button
only enabled in STATIC or ALU S correction.
Indication of the longitudinal position of the unbalance ( INDICATION OF EXACT CORRECTION WEIGHT
POSITION ) is enabled
For selection of special functions
Balancing spin.
N.B. If the machine remains on this screen without being used for more than the time preset in the
Setup parameters (6), the screen automatically returns to the screen-save.