CHIEF KSA1020 - Manual (Page 10)

KSA-1020 Installation Instructions
10
9. Place mounting bracket over anchors and align mounting
holes in mounting bracket with holes in anchors. (See
Figure 14)
10. Insert 1/4-20 x 1-3/4" Phillips pan head screw (E) into
mounting hole on mounting bracket and into anchor (B) and
tighten until flush against mounting bracket. DO NOT
overtighten! (See Figure 14)
11. Repeat Steps 9 and 10 for remaining mounting hole.
Figure 14
Installing CPU Mount to Wall
CAUTION: Overtightening screws may cause wall bracket
to compress into soft wall surface resulting in difficult mount
installation.
1. Ensure bracket flag is in the open position. (See Figure 16)
2. Insert mounting buttons into the four large mounting holes
on the bracket and lower into place. (See Figure 15)
Figure 15
3. Move flag to closed position in order to fully secure mount
to bracket. (See Figure 16)
Figure 16
Steel Stud
Drywall
Anchor Metal Channel
Mounting Bracket
(SIDE VIEW)
(E) x 2
10
2
3
Latch open
Latch closed
(rear view)