CHIEF KSA1020 - Manual (Page 5)

Installation Instructions KSA-1020
5
ASSEMBLY
Installation of Protective Rubber Edging
1. Place four strips of protective rubber edging (C) over the
sharp edges located on the top and bottom of the mount (A).
(See Figure 1)
Figure 1
CPU Installation
1. Release bracket from mount by moving flag to open
position. (See Figure 2)
2. Remove bracket from mounting buttons on back of mount.
(See Figure 2)
Figure 2
3. If hanging mount underneath desk, remove mounting
buttons to reinstall them in the holes in which they will be
used.
• If mounting vertically, move mounting buttons to
the four holes on top of the mount. (See Figure 3)
• If mounting horizontally, move mounting buttons
to the top four holes on the back. (See Figure 3)
Figure 3
4. Loosen adjustment knob at the back of the mounting unit
and adjust height of mount to a height greater than the
height of the CPU. Loosen strap at the front of the mount if
necessary. (See Figure 4)
Figure 4
1
(C) x 4
(A)
1
2
Latch open
Latch closed
Vertical button location
Horizontal button location
4
Strap