CHIEF KSA1020 - Manual (Page 9)

Installation Instructions KSA-1020
9
Installing to Steel Studs or Drywall
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT!
1. Determine location for mount keeping in mind CPU size and
safety requirements.
2. Use the removed mounting bracket as a template and mark
through top and bottom holes of wall bracket making sure
mounting holes are centered on stud. (See Figure 10)
3. Drill two 1/2" diameter pilot holes at marked spots into wood
stud. (See Figure 10)
Figure 10
4. Hold metal channel on anchor (B) flat alongside plastic
straps and slide channel through hole. (See Figure 11)
Figure 11
5. Holding plastic straps on anchor (B), pull anchor away from
wall until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 12)
6. Slide plastic cap on anchor (B) towards wall until flange of
cap is flush with wall. (See Figure 12)
Figure 12
7. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 13)
8. Repeat Steps 4 through 7 for remaining mounting hole.
Figure 13
3
Mounting holes centered on stud
2
(B) x 2
Drywall
Plastic Straps
4
Plastic Cap
Steel Stud
Drywall
Anchor Metal Channel
(Side View)
6
(B) x 2
5
Plastic Straps
Steel Stud
Drywall
Anchor Metal Channel
Plastic Cap
(SIDE VIEW)
7