AT&T EL52209 - Manual (Page 9)

Getting started
4
Telephone base & charger installation
Install the telephone as shown below.
The telephone base is ready for table use. If you want to change to wall
mounting, see page 7 for details.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
www.telephones.att.com
, or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
5. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.
1. Plug one end of
the telephone
line cord into
the telephone
jack at the
bottom of the
telephone base.
3. Route the power
adapter cord
through the slot.
4. Plug the large end
of the AC power
adapter into a
power outlet not
controlled by a wall
switch.
2. Plug the small
end of the AC
power adapter
into the power
jack at the
bottom of the
telephone base.
If you have DSL high speed
Internet service, a DSL filter
(not included) is required.
Charger installation
Plug the AC power
adapter into a power
outlet not controlled
by a wall switch.
Telephone line cord