FlexLink Spiral Elevator - Manual (Page 35)

Mounting, installation, adjustment
Create
d
by EBCCW
0
0
:06
Page 29 of 68 5478EN-3
5.2 Assembly
This paragraph describes a number of operations for Spiral Elevators that
are not delivered fully assembled. After having finished mounting the Spiral
Elevator, the Spiral Elevator can be integrated (Section 1.4) in a system.
5.2.1 Motor
The gear motor may be delivered separately with the Spiral Elevator and
then has to be mounted on site.
First check if all the required parts are present:
• Gear motor
• Grease
• Torque arm
• Key for shaft
• Fasteners (screw and washer)
The key and torque arm fastening to the frame may be pre-assembled.
The required tools are:
Procedure:
• Determine the installation orientation of the gear motor.
• Apply installation grease on the shaft to slide the gear motor onto
the shaft easier and prevent any fretting corrosion.
• Attach the torque arm to the gear motor with the appropriate
fixings.
• Place the locking ring (circlip) in the gear motor or move to the
desired groove in gear motor (if not already in the correct
position).
Open-end spanner Ring spanner Internal spring pliers