Burkert Type 8644 - Manual (Page 65)

65
Start-Up
10. sTarT-up
safety instructions 10.1.
WArNINg!
risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the device and the area around it.
Before start-up, ensure that the operating personnel are familiar with and completely understand the contents •
of the operating instructions.
Observe the safety instructions and intended use. •
Only adequately trained personnel may operate the equipment/the device. •
fluid start-up 10.2.
NoTE!
Switch on the supply pressure. •
Only then switch on the power supply! •
procedures before fluid start-up
Check connections, voltage and operating pressure!
→
Ensure that max. operating data (see type plate) are not exceeded!
→
Check that connections 1 and 3 or 5 have been configured correctly; these must not be mixed up!
→
Release manual actuation during electrical operation!
→
electrical start-up 10.3.
Information on electrical start-up may be found on the Internet under:
www.wago.com Documentation Wago I/O - System 750
Typ 8644
deutsch