Burkert Type 8793 - Manual (Page 53)

53
Installation
Type 8792, 8793
english
14.2.2. X4 - M8, 4-pole socket (for binary outputs option only)
Output signals to the control centre (e.g. PLC)
Pin Configuration On.the.device.side External.circuit./.Signal.level
1 Binary output 1 1 0 – 24 V
2 Binary output 2 2 0 – 24 V
3 Binary output GND 3
GND (identical with the GND operating
voltage)
Table 14: Pin assignment; X4 - M8, 4-pole socket - output signals to the control centre
When the operating voltage is applied, the positioner is operating.
→
Now make the required basic settings and actuate the automatic adjustment of the positioner. The procedure is
described in chapter “21. Start-up sequence”.