Burkert Type 8025 - Manual (Page 12)

12
Installation and wiring
Type 8025 UNIVERSAL
Protect▶this▶device▶against▶electromagnetic▶interference,▶
ultraviolet▶rays▶and,▶when▶installed▶outdoors,▶the▶effects▶of▶
the▶climatic▶conditions.
7.2 Installation of a panel version
Install▶the▶panel▶version▶of▶the▶device▶in▶a▶cabinet▶with▶a▶
protection▶class▶at▶least▶IP54▶to▶ensure▶a▶degree▶of▶pol-
lution▶2▶inside▶the▶cabinet.
▶ →
To▶cut▶the▶opening▶in▶the▶cabinet▶door,▶use▶the▶supplied▶drilling▶
jig,▶respecting▶the▶dimensions▶indicated▶in▶„Fig.▶4“.
95
80
76
50
95 80 76 50
Fig. 4: Dimensions of the drilling jig [mm]
▶ →
Insert▶the▶4▶screws▶in▶the▶housing▶(from▶the▶front).
▶ →
Insert▶the▶seal▶on▶the▶external▶threads▶of▶the▶4▶screws▶(rear▶of▶
the▶housing).
▶ →
Put▶the▶assembly▶on▶the▶cutout,▶electronics▶turned▶to▶the▶inside▶
of▶the▶cabinet.
▶ →
Put▶the▶4▶washers▶on▶the▶4▶screws.
▶ →
Put▶a▶nut▶on▶each▶of▶the▶4▶screws▶and▶tighten▶the▶nuts▶to▶secure▶
the▶device▶to▶the▶cabinet.
Seal
Nut
Washer
Screws
Cable▶clip
Fig. 5: Installation of a 8025, panel version
English