Fluid Components International ST100 Series Modbus User Manual
Page 9
Advertising
ST100 Series Modbus Operation
Fluid Components International LLC
5
1B.
Once you defined the data, go to the “Connection tab” and click on the “Connect”. Below window will apper. Set the all
parameters as per the settings.
Figure B
1C.
After user finishes all the above steps, ModScan32 master should communicate with the device (ST100). See below Figure C for
the successful communication.
Figure C
Figure D
2. How to check the “Totalizer Counter” number?
• Repeat the step (1A) with the different register numbers. Set the registers #4113 and #4114.
• Repeat step (1B) and (1C).
• See below Figure D for the “Roll-over count” number.
Advertising