GF Signet 3-0250 USB to Digital (S3L) Configuration-Diagnostic Tool - Manual (Page 4)

4 Signet 0250 Setup Tool
Serial Number, Sensor Type:
• This sensor information is read from the Magmeter when you press the "Read" button.
Messages:
• Displays messages related to the current selection. Error messages and procedure instructions will appear here.
• To repeat the same settings in another Magmeter, disconnect the Magmeter and connect the second Magmeter.
Note: For 4-20 mA models, remove 24 VDC power before rewiring.)
• Click "Write" again.
Note: All settings are lost when you exit the program. If the settings will be used again, click "SAVE". Name the fi le and save it on
the computer hard drive.
• Read: Read and display the existing settings from the Magmeter.
• Write: Write from the display into the Magmeter.
• Save: Save from the display to a fi le (*.bdf).
• Load: Load from a saved fi le into the display.
• Factory: Restores Application, Loop and Performance settings to original factory values.
Note: The blue LED on the 3-0250 blinks during data communication between the computer and the sensor.
GND
Data
+5V from USB port
Blue LED indicates data transmission
Red LED indicates power
4. Click "Write" to copy the new settings into the Magmeter.
Sensor Information
Controls