Global Specialties 1505 - Manual (Page 8)

SECTION - 5
SERVICE AND WARRANTY INFORMATION
FACTORY SERVICE AND REPAIR
Global Specialties will service and repair this instrument free of charge for
a period of one full year, subject to the warranty conditions stated below.
To obtain a return merchandise authorisation (RMA) required for all
returns, phone our Customer Service Department for a RMA and all
shipping instructions :
GLOBAL SPECIALTIES
22820 Savi Ranch Parkway,
Yorba linda, CA 92887
WWW.globalspecialties.com
800-572-1028
WARRANTY
Global Specialties warrants this device to be free from defective material
or workmanship for a period of one full year from the date of original
purchase.
Global Specialties under this warranty is limited to repairing the defective
device when returned to the factory, shipping charges prepaid, within one
full year from the date of original purchase. Units returned to Global
Specialities that have been subject to abuse, misuse damage or accident,
or have been connected, installed or adjusted contrary to the instructions
furnished by Global Specialities, or that have been repaired by unauthorized
persons will not be covered by this warranty.
Global Specialities reserves the right to discontinue models, change
specifications price or design of this device at any time without incurring
any obligation whatsoever.
The purchaser agrees to assume all liabilities for any damages and/or
bodily injury which may result from the use or misuse of this device by the
purchaser, his employees or agents.
This warranty is in lieu of all other representations or warranties expressed
or implied and no agent or representative of Global Specialties is
authorized to assume any other obligation in connection with the sale and
purchase of this device.
Specifications subject to change without notice.
5

!!Copyright 1994, INTERPLEX ELECTRONICS, INC,
Unit No.2, Highland Industrial Centre 1486, Highland Avenue,
Cheshire CT 06410, U.S.A.
!!and TM trademarks are the property of INTERPLEX
ELECTRONICS, INC, Unit No.2, Highland Industrial Centre
1486, Highland Avenue, Cheshire CT 06410, U.S.A.
CASE DISASSEMBLY AND ASSEMBLY
WARNING
Potentially lethal AC power is present whenever the line cord is
plugged into the AC outlet, even when the power switch is OFF.
Always disconnect the power cord when opening the case. Avoid
touching the fuse post on the inside of the unit.
Should access to the inside of the unit be required, proceed a follows:
1. Remove the line cord from the AC outlet before disassembly.
2. To disassemble the case, remove the screws that secure the cover
to the chassis and lift the cover off.
3. To reassemble the case, place the cover on the chassis, line up
the screw holes, and replace the screws.
MAINTENANCE AND RECALIBRATION
ADJUSTMENTS
All circutry is factory-calibrated. No user adjustments are required.
FUSE REPLACEMENT
Remove the line cord from the AC outlet before changing fuses. Using a
screwdriver, remove the fuse holder cap. Replace the fuse with another
fuse of identical type and current rating. Replace the fuse holder cap.
6