GxT Ferret 21 Smoke - Manual

1 www.ferretinstruments.com
OPERATORʼS MANUAL
CoolSmoke EVAP Leak Detector
21
WARNING: Before introducing pressure and fog to any system, the unit must be
calibrated using shop air. Failure to calibrate the unit before each use may result
in damage to the EVAP or other system under test. Always begin testing using
the lowest psi setting. Only increase the pressure when test conditions and the
system under test require it.
WARNING: The unit should be used on a level surface. This will make sure that
the fl ow meter reads accurately.
Timer
12 Volt
Power Leads
Shop Air In
Pressure
Gauge
Foot Switch
Port
Flow Light Polarity Light Flow Gauge
Fog Out
Mode Switch
Regulator
Control