Hydrotech 5600 SXT Valve nextSand Turbidity & Sediment Filter Operation Manual - Manual (Page 9)

7
Set treated water capacity (only available in metered systems)
1. Set time of day to 12:01 PM.
2. Press Extra Cycle button to exit the time of day display.
3. Press and hold the Up and Down buttons together until the programming icon replaces the service icon.
4. Press Extra Cycle button till “C” is displayed in the upper left corner of the screen.
5. Use Up and Down buttons to set the amount of treated water that can flow through the unit before a regeneration is
required.
6. Press Extra Cycle button until it shows the “Time of Day” display.
THIS IS AN OPTION ONlY. PlEASE DO NOT ADjUST bEFORE CONSUlTINg AN AUTHORIzED DEAlER.
650 gallon capacity
Error Display Example
NOTE: Unit will flash when an error exists.
Error Codes
Note: Error codes appear on the In Service display
Error Code Probable Cause Recover and Resetting
[Err 0]
[Err 1]
[Err 2]
[Err 3]
Drive motor is stalled
Drive motor is running continuously
There have been more than 99 days since
the last Regeneration. If the Day of the
Week mode of regeneration is selected
and days since last regeneration exceeds
7 days.
[ 7 - - 5 ]: There have been more than
7 days since the last regeneration. All
individual settings (d1, d2, d3, d4, d5, d6,
d7) are set to 0.
Control board memory failure.
Unplug the unit from the power source
When power is restored to the unit, the Err _ display
code clears. If the condition causing the error has
not been resolved the Err _ code reappears in the
four digit display. Do not attempt to troubleshoot this
problem any further.
Regeneration must occur for the unit to recover, the
display to clear and the valve to
function normally.
[ 7 - - 5 ]: To recover from [Err2], the user must
initiate a regeneration or set at least one individual
day to 1.
Perform a Master Reset. If the error returns,
do not attempt to troubleshoot this problem any
further.