Hydrotech 5600 SE Valve Iron & Sulfur Filter Operation Manual - Manual (Page 7)

5
Operating Instructions
The valve has been pre-programmed with factory settings as follows:
Regeneration Cycle Step Programming
1. Backwash ..................................10 minutes
2. Brine Rinse ..................................50 minutes
3. Rapid Rinse ................................10 minutes
4. Brine Refill ..................................4 minutes
Installation Tip: The 5600SE Filter should not be allowed to regenerate at the same time as any other water
treatment units. If adjustment is required, consult programming chart to adjust default regeneration time.
Default setting is 11:00 pm.)
Set Down Button
Set Up Button
P.M. Indicator
Flow Indicator:
Flashing Dot With Water Flow
Service Indicator:
Valve in Service - Dot On
Extra Cycle Tonight - Flashing Dot
Figure 3