Clear-Com AES-6 - Manual (Page 17)

Vitec Group Communications
AES-6 Digital Interface Instruction Manual 2 - 3
ECS. Currently it is required that the pair of matrix ports comprising a
single stereo channel must be adjacent ports.
Figure 2-6: AES-6-CX Card Connected for Stereo
For each BNC port to be connected in stereo mode the front DIP
switch must be set to the ‘ON’ position.
An example of the type of panel that could be used with the AES-6-CX
card in either mono or stereo mode is the Clear-Com 4222E panel.
AES-6-RJ INTERFACE CARD
The AES-6-RJ rear card has six pairs of RJ-45 ports allowing 4000
Series II panels, V-Series panels with an AES-3 interface and third
party equipment to be connected using CAT5 cable. The third party
equipment may be of any compatible type that provides a digital
interface. These cards may be configured for monaural or stereo use.